Saturday, October 5, 2013

LM2758 FLASH LED DRIVER EVALUATION BOARD ELECTRONIC DIAGRAM


LM2758 FLASH LED DRIVER EVALUATION BOARD ELECTRONIC DIAGRAM

To startup the Evaluation board, set the EN1 jumper and EN2 jumper to the “OFF” position, apply power to the board, and then move the EN jumper(s) to the “ON” position. This is the expected startup operation in the typical application where VIN is tied to a voltage rail and the EN pins are controlled via logic signal.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.