Thursday, December 6, 2012

Battery eliminator circuit



Description.

Here is the circuit diagram of a battery eliminator circuit that can be used as a replacement for 9V PP3 batteries. The circuit given here can be used to power any device that operates from a 9V battery. The transformer T1 steps down the mains voltage and bridge D1 performs the job of rectification. Capacitor C1 is a filter. IC LM317T is the regulator here. The value of R1, R2 and R3 are so selected that the output voltage of IC1 will be steady 9 volts.

Circuit diagram.

battery eliminator circuit
Notes.


  • Assemble the circuit on a good quality PCB.
  • Transformer T1 can be a 230V primary, 9V secondary, 1.5A step down transformer.
  • If 1A Bridge is not available, then make one using four 1N 4007 diodes.
  • Do not connect loads that consume more than 1.5A to this circuit.
  • A heat sink is recommended for IC1.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.